We access roof terminations, attic runs and open up walls for repairs. It’s important to view the ductwork from end to end as it provides a detailed look at the duct system.
Island Range Hood
Roof Vent w/ Damper Clogged by Dryer Lint
4-Way Roof Vent (Clogged) - Incorrect by building code
Kitchen Remodel with New Range Hood rough in and install
Turtle vent or box vent - Incorrect vent type for dryer venting by building code
Routed Dryer Duct around LVL beam- Builder Error-terminated inside the wall of a vaulted ceiling
Gooseneck roof vent w/ Screen - Installed by a roofer (by code dryer vent should not have a screen)
Clogged Dryer Vents lead to excessive moisture and eventually rust and deterioration
Tortoise Shell Vent - not up to building code
Bottom side of a tortoise shell roof vent- clogging and moisture accumulation of the roof decking
Patio Grill Range Hood
Tortoise Shell Roof Vent - Incorrect by code for dryer venting
Accessing a dryer duct inside a porch roof without attic access. Repairing duct and installing a new roof vent
Bottom side Tortoise Shell Roof Vent - Incorrect by code for dryer venting due to screen and no damper system
Recessed Range Hood Duct, Vent and appliance install.
3 Inch Nautical Vent- Incorrect by building- Minimum dryer vent size 4 inches and built in screen
Old Plastic ducting used to route dryer exhaust in the attic and a customer's lint brush stuck inside-rigid all metal duct is required by code
Microwave ducted and vented to the outside wall
A Wall Vent with a built in screen from manufacturer -this should be removed per building code
Broken Dryer Ducting that was not connected to roof wood decking, disconnecting when customer had new roof installed-Roofers don't go inside attics
3 Inch Nautical Vent back side- Incorrect by building- Minimum dryer vent size 4 inches and built in screen
6" wall coring for a Microwave venting system
6" Flush mount Magnetic Wall for range hood ducting
Range Hood duct transition to wall vent
HVAC Duct Pie Box- Ducts should be run directly back to the supply source or split with a "wye" for optimized cfm
Island Range Hood Install with new 6" ducting, electrical and vent.
Microwave ducted between floors to a sidewall vent. Drywall chase built around duct for concealment.
Coring a 4" hole through wall for a dry vent duct and exterior wall vent
About
Dryer Vent and Duct Repair Company in Austin who repairs vent work to building code. We are HVAC licensed, Insured and complete the roof work, wall coring, duct building, repair inside drywall cavities as well as the dryer vent cleaning.